That cable is too thin for 16A
Supposedly 0.5mm² of copper
Is that really copper?
No external fuse access ;-(
DMM A/D
Power supply - load test
Power supply - load test
LED-strip + custom controller
LED-strip + custom controller
Death Trap 1 of 5
Death Trap 2 of 5
Death Trap 3 of 5
Death Trap 4 of 5
Death Trap 5 of 5
Orange on blue
One out of 300...
Offending LED removed
Fixed - which one ?
Half-Ohm mΩ DMM adapter
Half-Ohm mΩ DMM adapter
Panelmania
Panelmania
Stamp from Estonia
16A... sure...
Good IEC plug
BAD IEC plug
LED strip - brightness vs. position
Lifetime supply of 100nF caps
Clouds
Flux transfer - success
Flux transfer - 1st attempt
Integrated O-ring
New flux-capacitor
Damaged Flux-capacitor
Cooking for dummies
What does it say?
Japanese stamp
Akafugu LED candle
Akafugu LED candle
Semi broken WMRP RT3
Akafugu LED candle
Akafugu LED candle
Akafugu LED candle
Tiny 1k resistor
Akafugu LED candle
See also...
Keywords
Authorizations, license
-
Visible by: Everyone -
All rights reserved
-
101 visits
16A... sure...
You need ad least 1.5mm² to handle 16A safely. 0.5mm² is simply not enough! But does the actually have 0.5mm² of copper inside? Let's check!
- Keyboard shortcuts:
Jump to top
RSS feed- Latest comments - Subscribe to the comment feeds of this photo
- ipernity © 2007-2024
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter
Sign-in to write a comment.