jyetech scope - "empty" board
jyetech scope - all finished: back side
jyetech scope - probe assembly 3/7
jyetech scope - probe assembly 5/7
jyetech scope - SMD parts done
jyetech scope - probe assembly 7/7
now I hate wires
imgp1995
imgp1996
a long way to go
almost done ?
creative chaos
imgp2000
imgp2001
imgp2006
imgp2007
imgp2008
imgp2009
Jyetech scope - improved back plate
Jyetech scope - improving the back plate
Jyetech scope - improved back plate
RGB Matrix V3.04 - back
RGB Matrix V3.04 - front
jyetech scope - other parts
jyetech scope - empty backside
jyetech scope - probe assembly 1/7
jyetech scope - probe assembly 6/7
jyetech scope - probe assembly 2/7
jyetech scope - probe assembly 4/7
jyetech scope - only back side done
jyetech scope - 7805 regulator test
jyetech scope - 7805 regulator test
jyetech scope - LCD
jyetech scope - all done: front side
jyetech scope - LCD assembled
jyetech scope - fully assembled after milling
jyetech scope
jyetech scope
jyetech scope
jyetech scope
imgp2226
SeeedStduio
jyetech scope - fully assembled
jyetech scope - front panel too small
jyetech scope - front panel too small
See also...
Keywords
Authorizations, license
-
Visible by: Everyone -
All rights reserved
-
102 visits
jyetech scope - SMD parts
Make sure D1/D7 are placed correctly. The opamps will survive the reversed zener diode (D1), but the other one (D7) is used for a boost converter which DIES if it is put in wrong.
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
Please note that a new hardware version of this device has been released, therefore these images will most likely not apply to it.
- Keyboard shortcuts:
Jump to top
RSS feed- Latest comments - Subscribe to the comment feeds of this photo
- ipernity © 2007-2024
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter
Sign-in to write a comment.