Waiting resistor
Mask removed
Tinned
Resistor's new home
Offender removed
Hopefully fixed - 8 more to go
Patch applied
KiCad / gerbmerge panelization
Sour...
Soylent Green ?
This could cost a lot to fix...
Fixed with Sugru!
Worn saddle with Sugru
Entirely fixed
Colourful but mediocre in taste
Pork belly with sausage
LED-strip PWM / IR controller
Fried meat
Creamy berries
Egg-cited!
FAT with sauerkraut
6-Million-Cent-Man - Rev 0.001
LED_port-status
About to cut a trace
Planned ESD protection
Hotplate SMD reflow
LED runway
Peppery pork belly
Pushing up the daisies
230V DC motor
Graphite brush
230V DC motor
AC stuff + bridge rectifier
Green PCB
Bread cutter innards
DC motor with fan
Bread cutter innards
Bread cutter - Safety switch
Bye bye wheat...
Quick & Tasty - Breakfast
Interlinked
Variations of White
Variations of Chicken & Bacon
Variations of Chicken & Bacon
Variations of Chicken & Bacon
See also...
Keywords
Authorizations, license
-
Visible by: Everyone -
All rights reserved
-
199 visits
Cut trace
The result is pretty good. I think I could use an even smaller tool (spear-point drill). Using sub-1mm fluted end-mills can get a bit tricky, especially if they're not of the short and stubby kind. They break quite easily - and cost a lot.
- Keyboard shortcuts:
Jump to top
RSS feed- Latest comments - Subscribe to the comment feeds of this photo
- ipernity © 2007-2024
- Help & Contact
|
Club news
|
About ipernity
|
History |
ipernity Club & Prices |
Guide of good conduct
Donate | Group guidelines | Privacy policy | Terms of use | Statutes | In memoria -
Facebook
Twitter
Sign-in to write a comment.