Pegasus Power box.

The addition of the small Pegasus power box was the last bit of my up grade to remove cables. The unit sits on a piece of flat aluminum that the Velcro fixed to the supports of the scope and some on the back of the small unit. It was not without work it was case of Solder new fittings and make a whole new power cable extension from the power adapter to the unit (Not plugged in).

To the right of the blue box is all the power plugs to the computer (just below) , the red focusor right end of the photo and the camera outside of view. Below I had to remove USB fittings and replace with RCA for both the heaters. to the left the computer cable for the unit( see two screens Below) and just below the 12 V 10A power inlet. Then it was fix and tie all the cables so everything it tied up and tight.

Also has auto dew heater tied up to the unit from the top cable and is the top part of the screen I prefer to have heaters on low full time, not auto. Blue , Red line and the large green part.




This shows the heaters powered up and camera powered.


Net result even more cables removed from the bottom of the mount to the top. Now its only two cables so far less weight than the 9 cables the mount had before. So far guiding has improved immensely. The effort has been worth while. Photo to follow from two nights note red and blue lines following the center line for a TOT bottom left corner 0.63 deviation.